Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| report [2014/06/26 14:21] โ [6.4 Functionalities] team2 | report [2014/06/26 14:23] (current) โ [6.5 Tests and Results] team2 | ||
|---|---|---|---|
| Line 1066: | Line 1066: | ||
| To verify the calculations that performed on the battery, the maximum current draw could be measured. This current should not exceed the 108.64 ๐๐ด. Also, an ammeter is needed to test it. | To verify the calculations that performed on the battery, the maximum current draw could be measured. This current should not exceed the 108.64 ๐๐ด. Also, an ammeter is needed to test it. | ||
| Assembly will follow the same pattern as the rest of the tests but the ammeter was placed between the battery and the boost converter as shown below: | Assembly will follow the same pattern as the rest of the tests but the ammeter was placed between the battery and the boost converter as shown below: | ||
| + | {{: | ||
| Figure 31 - Sketch of the mounting | Figure 31 - Sketch of the mounting | ||
